RCM222

The RCM222 is used to measure analog voltages and to output control voltages
 in the range of 0-10 V.This enables him to query and control electronic devices
 and sensors with a 0-10 V interface.The device has an Ethernet and an RS485 interface
 for connection to e.g. PC / process control system / Arduino or similar.

Features of the device:

Mechanical data:

Dimensions (L x W x H) Standard Version	approx. 160 x 130 x 50 mm with plugs lenght +20 mm
Weight Standard Version	< 0,5 Kg
Maximum conductor cross-section	to 1,5 mm²
Protection class	IP 30

Electrical data:

Power supply	12 V DC +- 5%
Power consuption	< 0,25 A

Analog inputs:

Number	two differential inputs
Measuring range  Uin- to Uin+	-10 V to +10 V
Common Mode area Uin-  to GND Uin+ to GND	0-10 V
Surge discharge/ESD	12W, 10%, 600W (Test waveform 10/1000µs)
Measurement error	<0,05 % FS
Temperature drift	< 10 ppm/ °C
Input impedance	>= 10MOhm
Resolution	24 Bit ADC

Analog outputs:

Number	two
Output voltage range	0-10 V (-10 V to +10 V, +-5 V, 0-5 V optionally possible)
Linearity error	<0,05 % FS
Temperature drift	<10 ppm / °C
Short circuit current	approx. 25mA
Nominal output current	+-10mA
Surge discharge/ESD	12W, 10%, 600W (Test waveform 10/1000µs)
Resolution	16 Bit DAC

Digital outputs:

Number and execution	two pieces of optically isolated SSR (Solid State Relais, AC possible)
Maximum switching current	1,0 A
Maximum switching voltage	60 V
Validation	no external fuse (F or FF) required

Interfaces:

RS485	Modbus RTU protocol, baud rate up to 921600 (tested)
Ethernet	10/100Mbit, DHCP support, port 5025, protocol similar to SCPI