PAKET_400AH_48V_BMS_VIS

Off-Grid Home Set
This package contains all the necessary components for a lithium battery system. This system is tuned to loads or inverters up to 12000 W. For a short time a load up to 24000 W is possible (about 10 minutes). The set include 3 charge controllers for up to 4.5 kWpeak Solar modules. The set also includes our greenView for visualizing the LiPros, greenControllers  and as a battery monitor with current-based SOC calculation! This System needs a inverter with control input, like a victron multi plus or victron quattro,
 

• Cells(16 x Winston LiFeYPO4 with 400 Ah/each)
• MountingSet: MONTAGE-KIT_16_400AHA
• Cell connectors (15 cell connectors to connect these cells in series for a 48V system)
• BMS (16 x LiPro1-6 Active)
• Adapter screws for mounting the BMS on the cells.
• Current sensor charging current: 100 A (200A or 400A on request)
• Current sensor load current: 400 A (100A or 200A on request)
• greenView (in the built-on or built-in version)
• 3 x greenController 140/30
• 2 x DC circuit breaker 1A for control circuits
• 3 x DC circuit breaker 30 A for solar charge controller
• NH fuse 250 A (with the necessary breaking capacity of > 20kA, including 2 replacement fuses)
• NH fuse holder
• FK6 connection cable: (FK6 cable for connecting the LiPros to each other)
• Control cable LIYY 10x0,14 mm²: 20 meters, to connect greenView
• KAB_BAL_ACTIVE_16 (When selecting LiPro1-6 Active)
• Wire end ferrules 
• High current cable 95 mm² NSGAFÖU: 10 meters. short-circuit proof according to VDE (double insulation) from the battery to the main fuse and the relay
• High current cable 10 mm² NSGAFÖU: 10 meters
• controll cables 1,5 mm² NSGAFÖU: 10 meters
• Suitable cable lugs and shrink tubing  
• Main Switch
• 2 x Busbars

Delivery free shipping (within germany)!
Please indicate above if you would like to get the greenView in built-on or built-in version.
 

Please note that any electrical installation work must be done by a licenced electrician.