SET_160AH_12V_BMS

This package contains all the necessary components for a lithium battery system. This system is tuned to loads or inverters up to 1 kW. For a short time a load up to 1,8 kW is possible (about 10 minutes). The inrush current must not exceed 1000 A/ 12 kW (10 ms)! 

• Cells (4 x Winston LiFeYPO4 with 160Ah/each TALL or WIDE)
• Mounting Set: MONTAGE-KIT_4_160AHA
• Cell connectors (3 cell connectors to connect these cells in series for a 12 V system)
• BMS (LiPro1-6 Active)
• Adapter screws for mounting the BMS on the cells.
• Safety shutdown, load shedding relay: greenSwitch 12/500
• Safety shutdown, charge switch-off relay: greenSwitch 12/500
• DC circuit breaker 1 A for control circuits
• NH fuse 80 A (with the necessary breaking capacity of > 10 kA, including 2 replacement fuses)
• NH fuse holder
• FK6 connection cable: (FK6 cable for connecting the LiPros to each other)
• Control cable LIYY 10x0,14 mm²: 2 meters, to connect greenView
• KAB_BAL_ACTIVE_4 
• Wire end ferrules 0.14 mm²
• High current cable 16 mm² NSGAFÖU: 6 meters. Short-circuit proof according to VDE (double insulation) from the battery to the main fuse and the relay
• Suitable cable lugs and shrink tubing  

At more than 30 A charge current and when the maximum efficiency is required, we recommend to select LiPro1-6 Active as BMS.
LiPro1-3 will go over the edge of the cell on one side. If you don't have space, we recommend select LiPro1-6 as BMS.

Delivery free shipping (within Germany)!
Please choose above if you would like to get the greenView in built-on or built-in version and the cell type.

Please note that any electrical installation work must be done by a licenced electrician.