SET_100AH_12V_BMS_VIS

This package contains all the necessary components for a lithium battery system. This system is tuned to loads or inverters up to 600 W. For a short time a load up to 1 kW is possible (about 10 minutes). The inrush current must not exceed 250 A/ 3 kW (10 ms)! The set also includes our greenView for visualizing the LiPros and as a battery monitor with current-based SOC calculation!
 

• Cells (4 x Winston LiFeYPO4 with 100 Ah/each)
• MountingSet: MONTAGE-KIT_4_100AHA
• Cell connectors (3 cell connectors to connect these cells in series for a 12 V system)
• BMS (LiPro1-1_RS485_V2 )
• Adapter screws for mounting the BMS on the cells.
• Safety shutdown, load shedding relay: SSR_30V_100A
• Safety shutdown, charge switch-off relay: SSR_30V_100A
• Current sensor charging current: 100 A 
• Current sensor load current: 100 A 
• greenView (in the built-on or built-in version)
• DC circuit breaker 1A for control circuits
• NH fuse 50 A (with the necessary breaking capacity of > 10 kA, including 2 replacement fuses)
• NH fuse holder
• FK6 connection cable: (FK6 cable for connecting the LiPros to each other)
• Control cable LIYY 10x0,14 mm²: 10 meters, to connect greenView and BMS
• Control cables LIYY 6x0,14 mm²: 20 meters, to connect greenView and current Sensors
• Control cables 0,75 mm²
• Wire end ferrules 
• High current cable 10 mm² NSGAFÖU: 6 meters. Short-circuit proof according to VDE (double insulation) from the battery to the main fuse and the relay
• Suitable cable lugs and shrink tubing  

Delivery free shipping (within Germany)!
Please choose above if you would like to get the greenView in built-on or built-in version.

Please note that any electrical installation work must be done by a licenced electrician.