Deutsch English

greenSwitch 12/500

greenSwitch 12/500

195,01 EUR

19 % VAT incl. excl. Shipping costs

Shipping time: 2-3 Workingd Days

Product no.: BG112

Print datasheet

GreenSwitch 12/500


GreenSwitch is a remote control circuit breaker for switching large currents safely. Remote control is either via an optional control switch or via greenView.

GreenSwitch has two inputs (LVP and OVP) for the direct connection of a battery management system (BMS). However, it can also be used as a normal power relay.

The device supports various operating modes when connecting a BMS, which can be selected via a dip switch:

Mode 0, LVP:
The device responds only to the LVP control signal from the BMS.
For switching loads (inverters, motors, etc.) to protect the battery from deep discharge

Mode 1, OVP:
The device responds only to the OVP control signal from the BMS.
For switching charging sources to protect the battery from overcharging

Mode 2, LVP:
Same as mode 0, but with inverted inputs.

Mode 3, OVP:
Same as Mode 1, but with inverted inputs.

Mode 4, LVP - OVP:
Both LVP (undervoltage) and OVP (overvoltage) are evaluated. Especially for users with finished system,
Which would like to convert to lithium batteries and charge and load is not easily separable due to the finished cabling.
Charging sources and loads are connected to the greenSwitch

Mode 5, LVP - OVP AUTO
Like Mode 4, however, the device automatically switches back after a protective shutdown.
If a shutdown due to deep discharge has occurred, is automatically switched back on when a
Charging source is detected.
If a shutdown due to overvoltage has occurred, it is automatically switched back on when a
Load is detected.

The last two operating modes have been specially developed for the conversion of existing lead-acid batteries to lithium technology for caravans and boats.

Switch states are indicated by LEDs on the device and the optional remote switch. When using greenView, e.g. The switching state, the temperature and the estimated current are graphically displayed on the TFT.

Further product features:

  • Water- and dust-proof housing (IP65)
  • Charge and load current up to 500A (continuous load)
  • Impulse load current up to 1500A (0.1s / 10s)
  • Temperature and overload cut-off
  • More than 10,000 switching cycles possible
  • Solid copper bars for easy and stable connection of the battery leads
  • RS485 BUS with open Modbus protocol
  • Low power consumption depending on the switching state 30-70mW (measured at 12V)
greenSwitch 12/500greenSwitch 12/500

Customers who bought this product also bought the following products:

LiPro1-6 Active

LiPro1-6 Active


New battery Mangment system (BMS) for cell monitoring and active load balancing (active balancing) of lithium cells
(Suitable for LiFeYPo4, LiFePo4 and other ...).
89,25 EUR (19 % VAT incl. excl. Shipping costs)

89,25 EUR per

FK6_050mm

FK6_050mm


 Ribbon cable :


- 50mm length

- 6 pin

- FEMALE IDC CONNECTEUR on both sides
1,96 EUR (19 % VAT incl. excl. Shipping costs)
FK6_140mm

FK6_140mm


 Ribbon cable :


- 140mm length

- 6 pin

- FEMALE IDC CONNECTEUR on both sides
2,00 EUR (19 % VAT incl. excl. Shipping costs)
KAB_BAL_ACTIVE_

KAB_BAL_ACTIVE_


Prefabricated cable set for simple and fast wiring of balancing connectors (LiPro1-6 active). Set Includes fuse holder, fuse and spare fuse.

from 11,90 EUR (19 % VAT incl. excl. Shipping costs)
greenController 75 / 40

greenController 75 / 40


SOLAR CHARGE CONTROLLER WITH MPPT TECHNOLOGY

Photovoltaic charge controller with maximum power point tracking, graphic display, RS485 communication and many more features. This version has a water and dust proof case. It doesn't has a GSM/GPS modul. It can't be remote monitored and controlled via mobile phone network.

399,00 EUR (19 % VAT incl. excl. Shipping costs)
LiPro1-3 RS485 V2

LiPro1-3 RS485 V2


This LiPro1-3 Module protects your Lithium ( LiFeYPO4, LiFePO4, ...) Batterie Cells. It protects every cell against deep discharge and overcharge furthermore it has a build in balancer circuit. This Version has a galvanically isolated RS485 interface.

48,73 EUR (19 % VAT incl. excl. Shipping costs)

48,73 EUR per

Shopping cart

You do not have any products in your shopping cart yet.

Welcome back!

Newsletter subscription

E-mail address:

The newsletter can be canceled here or in your Account at any time.

Customer group


Customer group: Guest

Manufacturer