SET_200AH_12V_BMS_VIS

This package contains all the necessary components for a lithium battery system. This system is tuned to loads or inverters up to 1200 W. For a short time a load up to 2000 W is possible (about 10 minutes). The inrush current must not exceed 1000 A / 12 kW (10 ms)! The set also includes our greenView for visualizing the LiPros and as a battery monitor with current-based SOC calculation!
 

• Cells (4 x Winston LiFeYPO4 with 200 Ah/each)
• MountingSet: MONTAGE-KIT_4_200AHA
• Cell connectors (3 cell connectors to connect these cells in series for a 12 V system)
• BMS (LiPro1-3_RS485_V2 or LiPro1-6 Active)
• Adapter screws for mounting the BMS on the cells.
• Safety shutdown, load shedding relay: greenSwitch 12/500
• Safety shutdown, charge switch-off relay: greenSwitch 12/500
• Current sensor charging current: 100 A (200 A on request)
• Current sensor load current: 200 A (100 A on request)
• greenView (in the built-on or built-in version)
• DC circuit breaker 1A for control circuits
• NH fuse 100A (with the necessary breaking capacity of> 20 kA, including 2 replacement fuses)
• NH fuse holder
• FK6 connection cable: (FK6 cable for connecting the LiPros to each other)
• Control cable LIYY 10x0,14 mm²: 10 meters, to connect greenView
• Control cable LIYY 6x0,14 mm²: 20 meters, for connecting greenSwitch or load relay
• KAB_BAL_ACTIVE4 (When selecting LiPro1-6 Active)
• Wire end ferrules 0.14 mm²
• High current cable 25 mm² NSGAFÖU: 6 meters. Short-circuit proof according to VDE (double insulation) from the battery to the main fuse and the relay
• Suitable cable lugs and shrink tubing  

At more than 30A charge current and when the maximum efficiency is required, we recommend selecting LiPro1-6 Active as BMS.
Delivery free shipping (within Germany)!
Please indicate above if you would like to get the greenView in built-on or built-in version.

Please note that any electrical installation work must be done by a licenced electrician.